| Home | Empennage kit | Wing Kit | Fuselage Kit | Finish Kit | Power Plant Kit | Avionics | Paint | Interior | Home |
|
|
|||||||||||
|
|||||||||||
| Home | Alterations | Vendors | Builders Log | Home |
|
Alteration 04 Canopy Lock / Lift / Alarm |
|
||||||||||||
| Page 04.01 - Canopy Lock | NOTE: Any alteration will require it to be registered as Experimental-Amateur Built E-AB | ||||||||||||
|
Parts
|
This Alteration is to add a Keyless Entry with Alarm and Email. It will also remove the handles and side tabs used in Vans Design. |
||||||||||||
| Step 01: Canopy Roll Bar Latch Lock |
 |
||||||||||||
| Step 02: Cut the F-1231A- FR & FL as shown in photo at left. |
 |
||||||||||||
| Step 03: Cut one of the F1231E as shown in the photo at the left. |
 |
||||||||||||
| Step 04: Make two
angles one right and one left to hold the latch. |
 |
||||||||||||
| Step 05: The latch and servo link. |
 |
||||||||||||
| Step 06: Servo Swing with adjusting bolt to allow the servo to swing forward to open canopy if the servo fail's. |
 |
||||||||||||
| Step 07: Swing support and release cam. |
 |
||||||||||||
| Step 08: Release Lever to drop the servo swing then pull down on the back of the swing to open the canopy. |
 |
||||||||||||
| Step 09: | |||||||||||||
| Step 10: | |||||||||||||
| Page 04.01: Canopy Lock |
|
|
|
||||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |