|
Page 15.08 Wing
Tanks
|
|
| This page will show the
test fitting and the design of the wing tanks |
| Step 01:
layout and cut the tank panels. |
 |
| Step 02: Bend the
panels. |
sorry no picture available see step: 09
to see the tank
|
| Step 03: Layout four
tank end caps and two tank baffles, three right and three left. Drill
holes in the four corners as shown. |
 |
| Step 04: Cut out the
all four corners |
 |
| Step 05: Bend three
with all tabs up and three with all tabs down |
 |
| Step 06: Bend the ends
in a home made break. |
 |
| Step 07: |
|
| Step 08: Install the
fuel pickup and the fuel gauge sender in one left and one right fuel
tank end caps. |
 |
Step 09: Test fit the
tank.
|
 |
| Step 10: |
|
| Step 11: |
 |
| |
|
| Step 12: The center
baffle is not attached as the design and location of this baffle has not
yet been determined |
|
| Step 13: |
 |
| Step 14: |
 |
| Step 15: Remove
tank and install the drain and home made check valve, also install a
cross baffle in the inboard bay |
 |
| Step 16: |
 |
| Step 17: The
finished design of the fuel tank |
 |
|
Page 15.08 Wing Ribs |
|
