|
Page 23.06 Side Skins
|
|
|
Step 01: Rivet the F-1202L Gussets to the F-1202E-L & R Bulkhead
Side Channels as shown in Figure 1. |
|
| Step 02: Cleco the
F-1270-L & R Fuselage Side Skins ( double check left and right ) to the
fuselage skeleton. Align the aft edge of the F-1234-L & R Canopy Decks
with the forward edge of the F1205B Roll Bar Attach Plates. Align the
vertex of the F-1255-L & R Longeron with the upper edge of the fuselage
side skin. Clamp the longeron to the fuselage side skin. Align the
outboard edge of the F-1205BRoll Bar Attach Plates with vertex of the
longeron. Clamp the roll bar attach plates to the longeron. |
|
| Step 03: Match-Drill
#30 and cleco all holes common between the F-1270-L & R Fuselage sides
Skins and the F-1255-L & R Longerons. Match-Drill #30 all holes common
between the F-12005 Roll Bar Attach Plates and the longerons. |
|
| Step 04: Remove, deburr
and prime the F-1255-L & R Longerons. Trim the tab from the aft edge of
the F-1270-L & R Fuselage Sides Skins as shown in the detail view in
Figure 1. Break the bottom and aft edge of both side skins ( See Section
5K ). |
|
| Step 05: Dimple the
nutplate holes around the triangular opening in the F-1270-L & R
Fuselage Side Skins ( flush outboard side ). The top center nutplate
hole is inaccessible with a 3" yoke. Dimple these holes using Bucking
Bar and a rivet gun ( See Photo ) Rivet nutplates to these holes as
called out in Figure 1. |
|
Step 06:Reassemble the
F-1255-L & R Longerons, F1234-L & R Canopy Decks and F-1270-L & R
Fuselage Side Skins in to the fuselage.
CAUTION: Do not rivet the
holes marked with a triangle in Figure 1. Cleco holes for later
assembly. |
|
Step 07: Rivet the
F-1270-L & R Fuselage Skins, F1255-L & R Longerons, F-1205A Roll Bar
Attach Plates and F-1234-L & R Canopy Decks to the fuselage assembly as
shown in Figure 1.
Note: CS Rivets used. |
 |
Step 08: Cut apart the
two F-1256 Skin Stiffeners. Rivet the skin stiffeners to the F-1270-L &
R Fuselage Side Skins.
03/06/14 |
 |
|
Page 23.06 Side Skins |
|
