|
Page 32.04: FLIGHT
CONTROLS |
|
Step 01:
Trim the corners from the two F-1262 Flap Handle Blocks as shown in Figure 1.
11/09/13 |
 |
Step 02: Secure the
Flap Handle / Pushrod Assembly to the inbord F-1215- L & R Seat Ribs
using the F-1262 Flap Handle Blocks and the hardware called out in
Figure 2.
Bulder Note: Alteration
Electric Flaps
11/09/13
|
 |
Step 02B:
Alteration
Make new brackets to replace vans system to
hold wires in the tunnel
See next photo |
 |
Step 03: Bolt together
the F-1219A & B Flaperon Mixer Arms ( installed previously, see Page
21-04, Figure 2. ) the F1263A & B Flaperon Mixer Bellcranks, and the
WD-1216 Flap Handle Pushrod using the harware shown in Figure 3.
This photo was taken out of order. |
 |
Step 04: Make two
F-1264 Control Stick Pushrods according to the demensions given in
Figure 4.
Builder Note: Cut and square off ends.
11/09/13 |
 |
| Builder Note: Drill
1 -1/4" deep. |
 |
| Builder Note: Tap
using the tail stock to keep tap in line. |
 |
| Builder Note: Finished
11/09/13 |
 |
|
Page 32.04: FLIGHT
CONTROLS |
|
