|
Page 37.01: FUEL TANKS |
|
| This page will show the
test fitting and the design of the wing tanks |
| Step 01:
Layout and cut the tank panels. |
 |
| Step 02: Bend the
panels. |
sorry no picture available see step: 09
to see the tank
|
| Step 03: Layout four
tank end caps and two tank baffles, three right and three left. Drill
holes in the four corners as shown. |
 |
| Step 04: Cut out the
all four corners |
 |
| Step 05: Bend three
with all tabs up and three with all tabs down |
 |
| Step 06: Bend the ends
in a home made break. |
 |
| Step 07: |
|
| Step 08: Install the
fuel pickup and the fuel gauge sender in one left and one right fuel
tank end caps. |
 |
| Step 09:Test fit the
tank. |
 |
| Step 10: |
|
| Step 11: |
 |
| Step 12: The center
baffle is not attached as the design and location of this baffle has not
yet been determined |
 |
| Step 13: |
 |
| Step 14: |
 |
| |
|
|
Page 35.01: LANDDING GEAR |
|
