Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 06.05 Vertical Stabilizer
6.00 6.01 6.02 6.03 6.04 6.05 6.06 6.07      
Step 01: Radius the edges at the narrow end of the VS-1205 Tip Rib, the VS-1206 Mid Rib and the VS-1202 Front Spar as shown in Figure 1.
A great way to cut the radius is with a fine file.
07-12-10
Step 02: Flute ( Section 5N ) between the holes in the flanges of the VS-1202 Front Spar and any of the other vertical stabilizer ribs as necessary to straighten the flange hole pattern.

Builder Note: Straighten, deburr and hold for priming
07-12-10
Step 02 A: ALTERATION

Dimple with a 120° Dimple Die
The Flanges of the VS-1202 Front Spar and all of the vertical stabilizer ribs

Photo Note: Some of the Photos on this site will show the Alteration.

09/23/10
.2 Hrs.
Step 03: Rivet the VS-1202 Front Spar, the VS-1208 Lower Main Rib, and the nutplates together. Orient rib flanges as shown in Figure 2. Flush rivet on the previously countersunk side of the front spar.
09/27/10
Step 04: Rivet the VS-1207 Upper Main Rib to the VS-1202 Front Spar. Hardware call-out and rib flange orientation shown in Figure 2.
09/27/0
NOTE: Rib flange orientation and hardware call-outs for Step 5 through Step 8 are shown in figure 3.

Step 05: Rivet the VS-1212-A-L & R Lower Spar Cap to the VS-1208 Rear Spar using the rivets called out. Place tape over the holes to be left open

Builder Note: Alteration
Rivets Used
09/27/10
T.2
Step 06: Rivet the VS-1207 Upper and VS-1208 Lower Main Rib to the VS-1203 Rear Spar and VS-1212A-L & R Lower Spar Caps.
09/27/10
Step 07: Rivet the VS-1206 Mid Rib to the VS1203 Rear Spar.
09/27/10
Step 08: Rivet the VS-1205 Tip Rib To The VS-1203 Rear Spar.

Refer to this Sub-assembly as the V-Stab Skeleton Assembly.
09/27/10
Page 06.05 Vertical Stabilizer
6.00 6.01 6.02 6.03 6.04 6.05 6.06 6.07      
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.