|
SPAR ASSEMBLY | REAR & STUB SPARS | WING RIBS | STALL WARNING | WING SKINS | FLAPERON | BUILDERS LOG |
Page 13.03 Spar Assembly |
|
|||||||||||
Step 01: Cleco the W-1206V Attach Angles to the W-1206-L & R,
Spar Assemblies as shown in Figure 1. Orient all of the attach angles so
the short flange, that contacts the web of the spar assembly channel,
points inboard. 05/13/15 |
||||||||||||
Step 02: Cleco the W-1206T Attach Angle to the outboard end
of the W-1206-L & R, Spar Assemblies as shown in Figure 1.
05/12/15 |
||||||||||||
Step 03: Rivet the
W-1206T Attach Angle to the W-1206-R Spar Assembly channel. Rivet the
inboard most W-1206K Attach Angle, which comes attached to the right
spar assembly, to the W-1206B Spar Stub Doubler as shown in Figure 2. 05/12/15 |
||||||||||||
Step 04: Rivet all of
the W-1206V Attach Angles to the W-1206-L & R Spar Assemblies. Rivet the
W-1206T Attach Angles to the left spar assembly as shown in Figure 3. 05/12/15 |
||||||||||||
Step 05: Rivet the
W-1206-L & R, Spar Assemblies at the remaining holes marked with the
symbol in Figure 3. 05/13/15 |
||||||||||||
Step 05: Rivet the
W-1206-L & R, Spar Assemblies at the remaining holes marked with the
symbol in Figure 3. 05/13/15 |
||||||||||||
Page 13.03 Spar Assembly |
|
SPAR ASSEMBLY | REAR & STUB SPARS | WING RIBS | STALL WARNING | WING SKINS | FLAPERON | BUILDERS LOG |
|
||||||||||
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |