Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Page 17.04 Wing Skins
17.01 17.02 17.03 17.04 17.05 17.06          
Step 01: Cleco the two center rib caps to the bottom of W-1201B-L inboard wing skin, then match drill and cleco as you go.

Layout and cut the hole for the fuel filler cap.


11/27/16
Step 02: Remove the rib caps, then deburr & dimple the new holes.


11/27/16
Step 03: Install the fuel tank and rib caps, then make the final connections for the fuel system.

12/23/16
Step 04: Cleco the W-1201B-L & W-1202B-L then river remove clecos as you go.
Leave the holes open for the W-1201C-L Wing Walk Doubler.

12/30/16
Step 05: Cleco the W-1201C-L Wing Walk Doubler to the wing as shown in Figure2.
Be sure to use flush head rivets.
 
Step 06: Repeat the apocopate steps for the right wing.

Builders Note: The left and right wing steps went hand in hand for most items.
 
   
Page 17.04 Wing Skins
17.01 17.02 17.03 17.04 17.05 17.06          
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.