Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 07.05 Rudder     
7.01 7.02 7.03 7.04 7.05            
Step 01: Remove the material shown hatched from the lower end of the R-1201 Main Skin shown in Figure 1.

07/17/10
Step 02: Position the R 1201 Main Skin  over the Rudder Skeleton Assembly. Check for main skin hole alignment with the Rudder Skeleton Assembly. Cleco the entire main skin to the Rudder Skeleton Assembly.

Builder Note:
Hold for Priming
07/17/10
Step 03: Starting nearest to the trailing edge rivet the R-1201 Main Skin to the Rudder Skelton Assembly per call-out in Figure 2. Leave open the top row of holes in the main skin.
10/09/10

Builder Note: Alteration
Rivets Used
Step 04: Close, and rivet the R-1201 Main Skin on the forward side of the R-1202 Spar. The skin must Overlap onto itself as shown in Figure 3.
10/09/10

Builder Note: Alteration
Rivets Used

NOTE: The rudder fiberglass fairing installation instructions are covered in Section 12: Emp Fairings
Page 07.05 Rudder
7.01 7.02 7.03 7.04 7.05            
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.