Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Page 15.02 Wing Ribs  
15.01 15.02 15.03 15.04 15.05 15.06          
The Left Wing only will be shown and the parts used. The instructions in the wing kit will be modified and not be the same as Van's Instructions.

The building of the wings will be modified to have flush rivets, fuel tanks and heated pitot tube with angle of attach
.
Builder Note: this section steps are modified to allow for the fuel tank installation.

Step 01: Flute, dimple and straighten 13 of the W-1208-R Nose Rib.
Mark the 13 ribs as L01, L02, L03, L04, L05, L06, L07, L08, L09, L10, L11, L12 and L14
Nose Ribs.

02/05/15
Step 02: Take Ribs L01, L02, L03, L04, L05, Nose Ribs. and trim the aft flange as shown in Figure 1.

Builder Note: Nose Ribs L06 and L07 are not trimmed.

02/07/15
Step 03: Take Rib L07 and dimple then install two nutplates for the stall warning switch as shown in Figure 5.  Builder Note: Nose Rib L08 is not trimmed 
Builder Note: For items not shown in this section See Alteration 06
Page 15.02 Wing Ribs 
15.01 15.02 15.03 15.04 15.05 15.06          
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.