Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Page 15.08 Wing Tanks  
15.01 15.02 15.03 15.04 15.05 15.06          
This page will show the test fitting and the design of the wing tanks 
Step 01: layout and cut the tank panels.
Step 02: Bend the panels.  sorry no picture available see step: 09 to see the tank  
Step 03: Layout four tank end caps and two tank baffles, three right and three left. Drill holes in the four corners as shown.
Step 04: Cut out the all four corners
Step 05: Bend three with all tabs up and three with all tabs down
Step 06: Bend the ends in a home made break.
Step 07:  
Step 08: Install the fuel pickup and the fuel gauge sender in one left and one right fuel tank end caps.
Step 09: Test fit the tank.
Step 10:  
Step 11:
   
Step 12: The center baffle is not attached as the design and location of this baffle has not yet been determined   
Step 13:  
Step 14:   
Step 15: Remove tank and install the drain and home made check valve, also install a cross baffle in the inboard bay  
Step 16: 

10/03/15
 
Step 17: The finished design of the fuel tank


10/03/15
 
Builder Note: For items not shown in this section See Alteration 06
Page 15.08 Wing Ribs
15.01 15.02 15.03 15.04 15.05 15.06          
SPAR ASSEMBLY REAR & STUB SPARS WING RIBS  STALL WARNING WING SKINS FLAPERON BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.