|
Page 23.04 Side Skins
|
|
|
Step 01: Cut apart then deburr The
F-1203H-L & R Arm Rest Brackets. See Figure 1. |
 |
| Step 02:
Rivet the F-1203H-L Arm Rest Brackets to the F-1203G-L Bulkhead Side
Channel as shown in Figure 2. Repeat this step for the right side of the
aircraft. |
|
| Step 03:
Rivet the F-1202E-L & R Bulkhead Side Channels to the F-1202F
Bulkhead per the callouts in Figure 2. Rivet the F-1203G-L & R Bulkhead
Side Channels to the F-1203A Bulkhead |
|
| Step 04:
Remove the tab from the notch in the F-1248-L & R Arm Rests that is for
the F-1203G-L & R Bulkhead Side Chanles. |
 |
| Step 05:
Match-Drill #30 forward tabs of the F-1248-L & R Arm Rests to the
F-1202E-L & R Bulkhead Side Channels. Match-Drill #30 the aft tabs of
the arm rests to the F-1204C-L & R Fwd Bulkhead Sides. Deburr the
bulkhead side channels and Fwd bulkhead sides. |
|
| Step 06:
Rivet a F-1248B Fuselage pin Latch to both the F-1248-L & R Arm Rests as
shown in Figure 3. |
|
| Step 07:
Rivet the F-1248-L & R Arm Rests to the F-1202E-L & R Bulkhead Side
Channels. Rivet the arm rests to the F-1204C-L & R Fwd Bulkhead Sides.
Rivet the arm rests to the F-1203H-L & R Arm Rest Brackets. See Figure
3. |
|
| Step 08:
Insert the F-1234-L & R Canopy Decks and F-1255-L & R Longerons ( should
still be clecoed together as an assembly ) into the fuselage
skeleton. Cleco the canopy decks to the upper tab in the F-1203G-L & R
Bulkhead Side Channels. See Figure 3. |
|
|
Page 23.04 Side Skins |
|
