|
Page 23.05 Side Skins
|
|
SB -12-11-09
This Service Bulletion
was copmleted at the time of construction
Builder Note:
Additional reninforcement was added buy the builder.
See
Alteration:
06 |
 |
Step 01: Cut out the wing spar penetration holes in the F-1270
Fuselage Side Skins to create left and right skins. Start by marking out
the shaded areas labeled in Figure 1 and 2. Drill a large hole with a
unibit inside the shaded area ( marked remove hatched area in Figure 1
and 2 ). Use snips to cut close to, but not at the edge of the shaded
area. Snip around a final time removing material up to the trim line
around the shaded area. Deburr the edge of the hole.
02/09/13
Builder Note: Cut with a razor knife, snap off and file to line. |
 |
| Step 02: Mark the
F-1270 Fuselage Skins left and right. |
|
| |
|
|
Page 23.05 Side Skins |
|
