Vans RV Builders List
Vans Models Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 10.03 Tailcone
10.01 10.02 10.03 10.04 10.05 10.06 10.07 10.08 10.09 10.10  
Step 01: Fabricate the F-1211G Tail Skid Bracket from the AEX Tie Down extrusion using the F-1211G-DT Drill Template as shown in Figure 1.

Remove drill template and deburr

08/11/10

Builder Note: Cut with band saw, Finish with Table sander and file, tap with 3/8"x16 starting and bottoming tap to a depth of 1 1/4"
Step 02: Remove the tabs from the F-1211B Bulkhead Doubler and deburr the bends called out in Figure 2.

08/11/10

Builder Note: Cut with band saw, Finish with Table sander and file
Step 03: Machine countersink the holes in the F1211B Bulkhead Doubler called out in Figure 2.

08/11/10
Step 04: Separate the F-1211D Attach Brackets by removing the material called out in Figure 3. Deburr.

08/11/10

Builder Note: Cut with band saw, Finish with Table sander and file.
Step 05: Mark, then separate the F-1284-L & R Shear Clips by removing the areas shown hatched in Figure 4.

08/11/10
Step 06: Mark, then separate the F-1211C-L & R Hinge Brackets by removing the areas shown hatched in Figure 5.

08/11/10

Builder Note: Cut with band saw, Finish with Table sander and file
Step 07: Mark the F-1283 J-Stiffener with the part numbers called out in Figure 6. Remove the area shown hatched to separate the F-1283A, B and C J-Stifeners.

08/11/10

Builder Note: Cut with band saw, Finish with Table sander and file.
Page 10.03 Tailcone
10.01 10.02 10.03 10.04 10.05 10.06 10.07 10.08 10.09 10.10  
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.