|
Page 11.02
Emp Attach |
|
|
Step 01:
Remove the VS-1204 Fwd Skin, the Lower Hinge Assembly and the hinge
hardware from the V-Stab Assembly. |
|
|
Step 02: Place a piece of
paper on top of the aft end of the Tailcone Assembly to prevent the
V-Stab Assembly from scratching the top skin. Deburr the bottom edge of
V-Stab Assembly. |
|
|
Step 03: Attach the rear
spar of the V-Stab Assembly to the Tailcone Assembly using the lower
four fasteners called out in Figure 1, Detail B-B
Do Not Tighten. Remove the protective paper. Attach the front
spar of the V-Stab Assembly to the Tailcone Assembly using the hardware
called out in Figure 1, Detail A-A, Do Not
Tighten. |
|
Step 04: Install the Lower
Hinge Assembly on the V-Stab and Tailcone assembly using the remaining
four fasteners called out in Figure 1, Detail BB. Tighten
ALL V-Stab Assembly attach bolts enough to
V-Stab Assembly movement.
Builder Note: |
|
|
Step 05:
Install the Rudder Assembly to the V-Stab Assembly using the hardware
called out in Figure 2. Refer to
Page 07-03-01 |
|
|
Step 06:
Check the Rudder Assembly to make Sure it swings freely. Rudder travel
in both directions should only be limited by the rudder horn contacting
the rudder stop shown in Figure 2, Detail C-C. |
|
|
Page 11.02
Emp Attach |
|
