Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 11.03 Emp Attach
11.01 11.02 11.03 11.04 11.05 11.06 11.07 11.08 11.09    
Step 01: Remove the AN4 bolt, used to locate the glued washers, from each of the stabilator hinge brackets, refer to Figure 2.  
Step 02: Rotate the WD-1223 Counterbalance Arm 90°, keep the counterbalance arm within both WD-122 Counterbalance Brackets. Insert the lead weights into the hole in the aft bulkhead of the Tailcone Assembly. Turn the counterbalance arm back to the original position as indicated by "top" from the previous step. Re-install the counterbalance hardware called out in Figure 1.  
Step 03: Install the Stabilator Assembly to the Tailcone Assembly using hardware called out in Figure 2.
Refer to Page 10-05-02 for previous information about glued washers.
 
Step 04: Check the Stabilator Assembly movement to make sure it swings freely. Stabilator travel in both directions should only be limited by the HS-1210 Hinge stops contacting the F-1211C Hinge Bracket shown in Figure 2, Detail A-A.  
Page 11.03 Emp Attach
11.01 11.02 11.03 11.04 11.05 11.06 11.07 11.08 11.09    
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.