Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 11.04 Emp Attach
11.01 11.02 11.03 11.04 11.05 11.06 11.07 11.08 11.09    
Step 01: Remove the hinge pin that was set aside on Page 08-03-05. Fabricate two hinge pins per dimensions given in Figure 1. File a dull point at one end and bend the other.  
Step 02: Install the Left and Right AST Assemblies to the Stabilator assembly, using the hinge pins fabricated in Step 1 as shown in Figure 2.  
Step 03: Attach the Left and Right AST Assemblies together using the hardware called out in Figure 3.  
Step 04: Rotate the hinge pins so the bent ends lay against the Stabilator Assembly. Fasten the bent ends of both hinge pins with safety wire through the #52  See Step: 09-09-02 holes called out in Figure 3, Detail A-A. Twist the safety wire on the inboard side of the Stabilator Assembly as shown.

Hereafter, refer to the Left and Right Assemblies as the AST Assembly.

Builder Note: The 1/16' holes in Figure 3 are #52 holes.
 
Page 11.04 Emp Attach
11.01 11.02 11.03 11.04 11.05 11.06 11.07 11.08 11.09    
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.