Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 12.02 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
Step 01: Ensure that the molded recessed area on both of the tip fairings has a square corner as shown in Figure 1. Use a razor blade or file to remove any material that may have been left from the mold  
Step 02: Trim any extra material from the recessed area of the R-1206 Rudder Tip Fairing per dimension given in Figure 2. Coarse 80 grit sandpaper on a wood block works well for this step.  
Step 03: Trim any extra material from the recessed area of the VS-1213 V-Stab Tip Fairing per dimensions given in Figure 3.  
Step 04: Trim the VS-1213 V-Stab Tip Fairing to within 1/8 inch of the aft scribe line as shown in Figure 3. Coarse 80 grit sandpaper on a cylindrical object works well for this step.  
Step 05: Place the R-1206 Rudder Tip Fairing onto the Rudder Assembly. The edge of the recessed area of the rudder tip fairing must be flush against the entire top of the R-1201 Main Skin.
To resolve interferences issues, recheck the recessed area measurement with the dimension given in Figure 2. Remove the minimum amount of material necessary, within that dimension, to achieve a flush fit to the top edge of the main skin
 
Step 06: While holding the  R-1206 Rudder Tip Fairing in place Match-Drill #30 the holes from the R-1201 Main Skin into the rudder tip fairing as shown in Figure 4. Cleco each hole before drilling the next.

Remove, clean and deburr, then re-cleco back in place.
 
Page 12.02 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.