Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 12.06 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
Step 01: Drill two holes with a step drill bit in the F-1294B Lower Tailcone Faring as shown in Figure 1. Drill two holes in each side of the lower tailcone fairing at the locations shown in Figure 1. Place the perimeter of all of the holes within the scribed lines.  
Step 02: Trim the excess material from the F-1294B Lower Tailcone Fairing as shown in Figure 1. Cut close to the scribe line, then use a sanding block to finish the edge to the scribe line.

Do not cut away the material between the two 3/4 inch holes drilled in Step 1.
 
Step 03: Drill a hole using a step drill bit in the F-1294A Upper Tailcone Fairing as shown in Figure 2. Drill two holes in each side of the upper tailcone fairing at the locations shown in Figure 2. Place the perimeter of the hole as close to the scribe line as possible.  
Step 04: Trim excess material from the F-1294A Upper Tailcone Fairing as shown in Figure 2. Cut close to the scribe line, then use a sanding block to finish the edge to the scribe line.  
Step 05: Align the forward edge of the F-1294B Lower Tailcone Fairing to the fairing edge line ( Ref Page 12-05 Figure 2 ) on tape 'BL' and 'BR' as shown in Figure 3. Temporarily tape or clamp the lower tailcone fairing to the tailcone.  
Step 06: Align the forward edge of the F-1294A Upper Tailcone Fairing to the fairing edge line on tape 'AL' and 'AR'. Align the notch from the 3/4 inch hole in the upper tailcone fairing with the 3/4 inch slot in the F-1294B Lower Tailcone Fairing.  
Step 07: Sand the called out edges of the F-1294A & B Upper and Lower Tailcone Fairings for best fit, with minimal gap, see Figure 3. The best fit edges will be finished in a following step.  
Page 12.06 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.