Page 12.05
Emp Fairings |
|
Step 01:
Separate the F-1294C Tabs by removing the material called out in Figure
1. |
|
Step 02: Mark two lengths
of masking tape per dimensions in Figure 2. One will be the 'AL', which
will be for the upper left half of the tailcone. The other will be the
'BL', which will be for the lower half of the tailcone. Use a pen that
makes dark lines.
Mark two more pieces of masking tape as a
mirror of the first two, label them 'AR' and 'BR' for the right side of
the tailcone |
|
Step 03: Place the forward
end of the reference line of tape 'AL on the lower edge of the F-1279-L
Upper Corner Skin. Align the forward edge of the masking tape along the
manufactured heads of the aft most rivet pattern on the tailcone as
shown in Figure 3. Gather wrinkles to the aft edge of the tape between
the fairing attach hole marks. |
|
Step 04: Place the forward
end of the reference line of tape 'BL' on the lower edge of the F-1280-L
Side Skin. Align the forward edge of the masking tape along the aft-most
rivet pattern on the tailcone as shown in Figure 3. Gather wrinkles in
the aft edge of the tape between the fairing attach hole marks.
Repeat Steps 03 and 04 on the right side of the Tailcone Assembly using
tape 'AR' and 'BR'. |
|
Step 05:
Measure and mark the dimension given from the aft edge of the tailcone
skins, at each fairing attach hole location as shown in Figure 3. |
|
Page 12.05
Emp Fairings |
|