Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 12.07 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
Step 01: With the F-1294A Upper Tailcone Fairing set aside, position the F-1294C Tabs on the Exterior surface of the F-1294B Lower Tailcone Fairing at the locations shown in Figure 1 ( exact location not critical ). Align the Edge of lower tailcone fairing to the reference notches on each edge of the tabs as shown in Figure 1, Detail A-A. If / as necessary slightly bend any tab to fit the curve of the lower tailcone fairing. Mark the locations and outer surface of each tab and clamp in place.  
Step 02: Match-Drill #40 one of the holes from a F-1294C Tab into the F-1294B Lower Tailcone Fairing. Cleco the hole then check the alignment of the opposite reference notch to the edge of lower tailcone fairing. Match-Drill #40 the second hole from the tab into the lower tailcone fairing. Remove, clear away chips and re-celco.

Repeat Step 02 with the remaining tabs.
 
Step 03: With the F-1294A & B Upper and Lower Tailcone Fairing attached to the tailcone as instructed on Page 12-06, Step 05 and 06, clamp the F-1294A Upper Tailcone Fairing to the F-1294C Tabs that are clecoed to the F-1294B Lower Tailcone Fairing.  
Step 04: Match-Drill #40 only the middle hole from each F-129C Tab into the F-1294A Upper Tailcone Fairing.

Separate the upper and lower fairings. remove the tabs, clean up the holes and clear away any loose material.
 
Step 05: Cleco the F-1294C Tabs to the inside surface of the F1294B Lower Tailcone Fairing. Cleco the F-1294A Upper Tailcone Fairing to the tabs as shown in Figure 2.  
Step 06: Final-Drill using a modified #27bit, then cleco each of the F1294C Tab center holes common to the F-1294A Upper Tailcone Fairing as shown in Figure 2. Remove the upper tailcone fairing and tabs, clear away loose material.  
Step 07: Machine countersink the outside surface of the F-129C Tab at each nutplate attach rivet hole as shown in Figure 3.  
Step 08: Rivet a nutplate to the inside surface of each of the F-1294C Tabs as shown in Figure 3.  
Page 12.07 Emp Fairings
12.01 12.02 12.03 12.04 12.05 12.06 12.07 12.08 12.09 12.10 12.11
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.