|
VERTICAL STAB | RUDDER | ANTI-SERVO TAB | STABILATOR | TAILCONE | EMP ATTACH | EMP FAIRINGS | BUILDERS LOG |
Page 09.04 Stabilator |
|
|||||||||||
Step 01:
Cleco the HS-1224 Doublers to the inner surface of the HS-1202 Fwd Spar
Web. Final-Drill #12 the 3/16" holes. 08/06/10 |
||||||||||||
Step 02: Final-Drill #40
the 3/32" nutplate attach rivet holes in the HS-1224 Doublers. 08/06/10 |
||||||||||||
Step 03: Bolt one of the
called out nutplates through one of the #12 holes in the HS-1202 Fwd or
HS-1203 Aft Spar for the WD-1207 Upper and WD-1208 Lower Horn.
Using the nutplate as a guide, match-drill #40 the first nutplate rivet
hole as called out in figure 1. cleco the first #40 hole, the
match-drill the other attach rivet hole. repeat this step for all the
nutplates that are common to the upper and lower horns in the Fwd and
Aft spar. 08/06/10 |
||||||||||||
Step 04: Machine
countersink the nutplate attach rivet holes flush on the other surface
of the HS-1202 Fwd and HS-1203 Aft Spar per call-out in Figure 1. Mark the positions, remove the nutplates and doublers, deburr all drilled holes, clear away chips and re-cleco 08/06/10 |
||||||||||||
Step 05:
Rivet the HS-1224 Doublers, and the called out nutplates to the inner
surface of the HS-1202 Fwd Spar web using rivets called out in Figure 1. 11/01/10 Step 06: Rivet the nutplates for the WD-1207 Upper and WD-1208 Lower Horn to the HS-1202 Fwd and HS-1203 Aft Spars using the rivets called out in Figure 1. 11/01/10 Builder Note: Photo taken after step:08 |
||||||||||||
Step 07:Rivet a
nutplate to both of the HS-1213B Out-bd Hinge Brackets using hardware
called out in Figure 2. 11/01/10 |
||||||||||||
Step 08: Rivet the
WD-1222 Counterbalance Brackets to the HS-1202 Fwd and HS-1203 Aft Spar
in there previously marked positions per call-out in Figure 3. 11/01/10 |
||||||||||||
Page 09.04 Stabilator |
|
VERTICAL STAB | RUDDER | ANTI-SERVO TAB | STABILATOR | TAILCONE | EMP ATTACH | EMP FAIRINGS | BUILDERS LOG |
|
||||||||||
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |