Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Page 09.10  Stabilator
9.01 9.02 9.03 9.04 9.05 9.06 9.07 9.08 9.09 9.10  
Step 01: Install the WD-1207 Upper and WD1208 Lower Horns to the Stabilator Assembly Using hardware called out in Figure 1. Builder Note: Step 01 thru 05 will be completed during Section 11: Emp Attachment and after painting.
Step 02: Insert the Wd-1223 Counterbalance Arm into the Stabilator Assembly. Align the previously match-drilled #12 holes in the counterbalance arm to the corresponding holes in the WD-1222 Counterbalance Brackets. See Figure 2.

NOTE: Figure 2 illustrates the hardware for the aft counterbalance bracket. The forward counterbalance bracket hardware fastens through the counterbalance arm in the same method shown.
 
Step 03: Temporarily install the WD-1223 Counterbalance Arm to each of the Counterbalance Brackets using the hardware called out in Figure 2.  
Step 04: Final-Drill #12 the holes in the R-1014 Counterbalance Weights.  
Step 05: Install the R-1014 Counterbalance Weights to the WD-1223 Counterbalance Arm with the hardware called in Figure 2.

NOTE: The Counterbalance Arm final installation and the Anti-Servo Tab installation will be completed during Section 11: Emp Attachment. 
 
   
Page 09.10  Stabilator
9.01 9.02 9.03 9.04 9.05 9.06 9.07 9.08 9.09 9.10  
VERTICAL STAB RUDDER ANTI-SERVO TAB  STABILATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.