| Home | Empennage kit | Wing Kit | Fuselage Kit | Finish Kit | Power Plant Kit | Avionics | Paint | Interior | Home |
|
|
|||||||||||
|
|||||||||||
| Home | Alterations | Vendors | Builders Log | Home |
| Alteration 10.01 Seat Brace |
|
||||||||||||
| Page 10.02 | NOTE: Any alteration will require it to be registered as Experimental-Amateur Built E-AB | ||||||||||||
|
Parts
|
This Alteration is to make the seat brace removable |
||||||||||||
| 01: The finished end of the brace. |
 |
||||||||||||
| 02: The finished end of the brace. |
 |
||||||||||||
| 03: The finished end of the brace. |
 |
||||||||||||
| 04: The finished brace. |
 |
||||||||||||
| 05: 1/4"28 bolts
2 each side to remove the brace 05/27/13 |
 |
||||||||||||
| Step 06: Use a 1/4"28 bolt with the head cut off to install the brace, then replace with a 1/4" 28 bolt. |
 |
||||||||||||
| Page 10.02 |
|
|
|
||||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |