Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
Home Alterations Vendors Builders Log  Home
Alteration 12 Electric Flaps
12.01                    
Page 01 NOTE: Any alteration will require it to be registered as Experimental-Amateur Built  E-AB

This page works hand & handwith page
32.04 Flight Controls

This Alteration is to add Electric Flaps

Step 01: Make the parts to replace vans WD-1213 Flap Handle

11/09/13
Step 02: A trick way to bore a hole with a 3 Jaw Chuck when the part wont fit in my 4 Jaw Chuck.

11/09/13
Step 03: After a little work in my
mill.

11/10/13
Step 04: Add a pin to connect to vans W-1216

11/28/13
Step 04B: Secure the custom Servo Lever & the Pushrod Assembly to the inboard F-1215- L & R Seat Ribs using the F-1262 Flap Handle Blocks and the hardware called out in Figure 2.

12/08/13



See 32.04 Flight Controls
 
Step 05: Layout the Servo Tray.

11/17/13
Step 06: Bend up the flanges, drill & cutout holes and layout for nutplates.

11/28/13
Step 07:Step 07: Add notches for snap bushings.

11/28/13
Step 08: Cut the appropriate holes in

11/28/13
Step 09: Make the servo anchor bracket.

12/01/13
Step 10: Scuff, clean, prime and test fit the parts.

12/14/13

Page 12.02 Electric Flaps
12.01                    
01: Flush Rivets 02: Stab Fairings 03: Static Air / Pitot 04: Canopy Lock / Lift  05: Battery Location 06: Fuel Tanks
07: Rear Windows 08: Engine 09: Seat Adjustment 10: Seat Brace 11: Brake System 12: Electric Flaps
13: Rudder Trim 14: Tailcone Fairing 15: Wing Skin Stiffeners 16: Wing Tip Lights 17: Rear Baggage 18: Tailcone Camera
19: Tailcone Stiffeners 20: Tie Down Rings 22: Vent Door Knobs      
           
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.