Vans RV Builders List
Vans Parts Joes RV 10
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
WING ATTACHMENT WIRING FLIGHT CONTROL  MISCELLANEA CANOPY INSTALLTION LANDING GEAR FUEL COWLING OPTION'S  BUILDERS LOG
Page 32.03: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
Step 01: Separate the F-1263 Flaperon Mixer Bellcrank into individual parts by removing the shaded areas shown in Figure 1.

11/10/13
Step 02: Rivet the VA-146 Flange Bearings to the F-1263A & B Flaperon Mixer Bellcranks using the rivets called out in Figure 2.

11/10/13

Step 03: Make the Flap Handel / Pushrod Assembly Using the parts and hardware shown in Figure 3. Thread the rod-end bearings to attain the dimension given in the figure ( note that the dimension is from the centerline of the rod-end bearing to the edge of the WD-1213 Flap Handel ) .

Builder Note: Alteration Electric Flaps
   
Page 32.03: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
CENTER SECTION MID FUSE LOWER FUSE  SIDE SKINS ROLLOVER TAIL ATTCH  SEATS PEDALS FUEL FWD FUSE  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.