|
Page 32.13: FLIGHT
CONTROLS |
|
Step 01:
Secure the F-1239 Rudder Cables to the Horns of the WD-1206 Rudder
Pedals using the F-1258 - L & -R Rudder Cables links and the hardware
called out in Figure 1.
12/25/13 |
 |
Step 02: Install the
bushing shown in Figure 2 between the F-1250 - L & - R Pulley Brackets
using the hardware called out.
12/25/13 |
 |
Step 03:
Secure the F-1247A Forward Stabilator Cables to the WD-1210 Control
Column using the hardware called out in Figure 3.
12/25/13
Step 04:Route the aft
end of both F-1247A Forward Stabilator Cables over the bushing and
through the hole in the F-1220B Aft Intercostal as shown in Figure 3.
12/25/13 |
 |
Step 05: Install the
two pulleys shown in Figure 3 using the hardware called out. Be sure the
F-1247A Forward Stabilator Cables are captured between the bushing and
the pulleys.
12/25/13 |
 |
Step 06:
Builders Note: I used a fiberglass
rod to install the aft ends of the cables to the stabilator.
12/25/13 |
N0 Photo |
|
Page 32.13: FLIGHT
CONTROLS |
|
