Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
WING ATTACH WIRING FLIGHT CONTROL  MISCELLANEA CANOPY LANDING GEAR FUEL COWLING OPTION'S  BUILDERS LOG
Page 32.09: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
Step 01: From the 12 inch length of MS21266-1N Nylon Grommet Supplied, cut two 3-3/16" lengths and install them around the edges of the holes in the F-1273-L & R Baggage Corner Skins as shown in Figure 1.  Not installed until after Vinyl Wrap.
Step 02: Slide the WD-1214-L & R Flaperon Torque Tubes through the holes in the F-1273-L & R Baggage Corner Skins and between the brackets of the WD-1215-L & R Flaperon Torque Arms as shown in Figure 1.

06/04/17
  Temporally install to test fit only, this will be accomplished after vinyl is complete
Step 03:  Pass the bolt through the holes in both F-1219 Flaperon Mixer Arms and through the holes in the F-126A & B Flaperon Mixer Bellcranks.

06/04/17
Temporally install to test fit only, this will be accomplished after vinyl is complete
Step 04: Install the wings. During installation, slide the A-1211 Pivot Guides into the WD-1214-L & R Flaperon Torque Tubes and the A-1207-L & R Actuation Brackets between the F-1261 Spacers as shown in Figure 4.

06/04/17
Page 32.09: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
CENTER SECTION MID FUSE LOWER FUSE  SIDE SKINS ROLLOVER TAIL ATTCH  SEATS PEDALS FUEL FWD FUSE  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.