Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
WING ATTACH WIRING FLIGHT CONTROL  MISCELLANEA CANOPY LANDING GEAR FUEL COWLING OPTION'S  BUILDERS LOG
Page 32.08: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
Step 01 Thru 05: Removed Alteration - Removing Flap Handle and Adding electric Flaps
Step 06: Cut the F-1261 into four individual parts according to the dimension given in Figure 3.
08/21/17
No Photo
Step 07: Position the F-1261 Spacers in the WD-1214-L & R Flaperon Torque Tubes as shown in Figure 4, then match-drill #30 the holes of the flaperon torque tube into the spacers. No Photo
Step 08: Final- Drill # 12 the two holes in each F-1261 Spacer ( the spacers only, not the flaperon torque tube ).

08/21/17
No Photo
Step 09: Scuff the mating surfaces, then epoxy the F-1261 Spacers to the F-1214-L & R Flaperon Torque Tubes. Do not use too much epoxy, a 1/8 inch gap must be maintained between the spacers ( use a scrap piece of 1/8" aluminum or something similar ). Before the epoxy sets. install the rivets called out in Figure 4.

08/2//18
NO Photo
Page 32.08: FLIGHT CONTROLS
32.01 32.02 32.03 32.04 32.05 32.06 32.07 32.08 32.09 32.10  
32.11 32.12 31.13 32.14              
WING ATTACH WIRING FLIGHT CONTROL  MISCELLANEA CANOPY LANDING GEAR FUEL COWLING OPTION'S  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.