|
Home | Alterations | Vendors | Builders Log | Home |
Alteration 17 Rear Baggage |
|
|||||||||||||||
Page 17.03 Making the storage compartment | NOTE: Any alteration will require it to be registered as Experimental-Amateur Built E-AB | |||||||||||||||
Parts
|
This Alteration is to add a Baggage area in the tailcone for items required to pre-flight and tie down the aircraft. It will also help with the W&B problem caused by the six cylinder Jabiru Engine |
|||||||||||||||
Step 01: Make the
rear baggage side walls from .024 2024 T3 aluminum. 09/18/17 |
||||||||||||||||
Step 02: Make the
rear baggage ceiling from .020 2024 T3 aluminum. Add nutplates as shown. 09/18/17 |
||||||||||||||||
Step 03: Cleco then
rivet the ceiling to the side walls as shown. 10/13/17 |
||||||||||||||||
Step 04: Completed
10/13/17 |
||||||||||||||||
Step 05: Install the
finished compartment to the supports with 15 8/32" SS screws. 10/14/17 |
||||||||||||||||
Page 17.03 Making the storage compartment |
|
|
|
||||||||||
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |