Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
CENTER SECTION MID FUSE LOWER FUSE  SIDE SKINS ROLLOVER TAIL ATTCH  SEATS PEDALS FUEL FWD FUSE  BUILDERS LOG
Page 21.08
Mid Fuse Ribs & Bottom Skins
21.01 21.02 21.03 21.04 21.05 21.06 21.07 21.08 21.09 21.10  
21.11 21.12 21.13 21.14 21.15 21.16 21.17 21.18 21.19 21.20  
Step 01: Rivet the F-1225-R Seat Floor to the remaining Right Seat Assembly ( except the hoe indicated ) and the Pulley Bracket / Seat Rib Assembly using the rivets called in Figure 1.  
Step 02: Dimple the nutplates shown in Figure 1, then rivet them to the Pulley Bracket / Seat Rib Assembly and to the F-1 225-R Seat Floor using the rivets called out . Again, temporarily install an 8-32 screw in the MS21051-L08 nutplate to prevent misalignment while riveting.  
Step 03: Using the rivets called out in Figure 1, rivet the F1253-R Seat Floor Support to the bottom of the F-1225-R Seat Floor as shown. Do not install a rivet in aft most and forward most hole as indicated.  
Step 04: Install the snap bushings called out in Figure 1.  
Step 05: Rivet the Left and Right Seat Floor Assemblies to the F-1204A Center Section Bulkhead using the rivets called out in Figure 2. Rivet call-ours apply to both Sides of the Fuselage.  
Page 21.08
Mid Fuse Ribs & Bottom Skins
21.01 21.02 21.03 21.04 21.05 21.06 21.07 21.08 21.09 21.10  
21.11 21.12 21.13 21.14 21.15 21.16 21.17 21.18 21.19 21.20  
CENTER SECTION MID FUSE LOWER FUSE  SIDE SKINS ROLLOVER TAIL ATTCH  SEATS PEDALS FUEL FWD FUSE  BUILDERS LOG
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.