21_09 Mid Fuse Ribs & Skins

CENTER SECTION

MID FUSE

LOWER FUSE

SIDE SKINS

ROLLOVER

TAIL ATTCH

SEATS

PEDALS

FUEL

FWD FUSE

BUILDERS LOG

Page 21.09
Mid Fuse Ribs & Bottom Skins

21.01	21.02	21.03	21.04	21.05	21.06	21.07	21.08	21.09	21.10
21.11	21.12	21.13	21.14	21.15	21.16	21.17	21.18	21.19	21.20

Step 01: Rivet the F-1204CL-L & R Fwd Bulkhead Side Assemblies to the Left and Right Seat Floor Assemblies using the rivets called out in Figure.

08/14/12

Step 02: Rivet one of the F-1204H Bulkhead Caps to the forward side of the F-1204B-L Aft Bulkhead Side and forward side of the F-1204CL-L Fwd Bulkhead Side Assembly using the rivets called out in Figure 2. Do Not rivet the three in the top flange of the bulkhead cap which are common to the aft bulkhead side, or the single hole in the bottom forward flange indicated in the figure.

Step 03: Slide the BUSHING AL .197 X .313 X 1.954 Bushing into the F-1204M Roller, then install them between the F-124B-L Aft Bulkhead side and the F-1204CL-L Fwd Bulkhead Side Assembly using the hardware called out in Figure 2. The bolt is secured with the nutplate attached to the back of the F-1204A Center Section Bulkhead

08/15/12

Step 04: Rivet the remaining F-1204H Bulkhead Cap to the forward side of both the F-1204B-R Aft Bulkhead Side and the F-1204CL-R Fwd Bulkhead Side Assembly using the rivets called out in Figure 3. Do Not rivet the three holes in the top flange of the bulkhead cap which are common to the aft bulkhead side, or the single hole in the bottom forward flange indicated in the figure.

Step 05: Slide the BUSHING AL .197 X .313 X 1.954 Bushing into the F-1204M Roller, then install them between the F-1294B-R Aft Bulkhead Side and the F-1204C-R Fwd Bulkhead Side Assembly using the hardware called out in Figure 3. Note that the roller on the right side of the aircraft is oriented in the opposite direction of roller on the left side.

08/15/12

Builder Note: Bolts left loose waiting for torque wrench