Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
Home Alterations Vendors Builders Log  Home
Alteration 07 Rear Windows
07.01 Aluminum 07.02 Plexiglass Windows  
Page 07.02 Plexiglass Windows NOTE: Any alteration will require it to be registered as Experimental-Amateur Built  E-AB
Parts
1 4' X 8' 2024T3 Sheet
1 F-1231B Roll Bar Strap
     
     

This Alteration will install two small rear windows

Additional information will be shown in the appropriate section

Step 01: Make two fiberglass molds using the location on the aircraft where the window's will be located, one left and one right.

04/15/15

Step 02: The Finished Mold.

04/15/15
 
Step 03: Use the fiberglass molds to bend the Plexiglass Windows

04/18/15
Step 04: Lay out then cut out window opening.



04/19/15
 
Step 05: Lay out then drill for screws in the left rear window.

04/19/15

Builder Note: This window will not be installed until a much later date.

The aircraft will have a vinyl wrap and both windows will need to be out.
Step 06: The layout of the right rear window.

04/18/15
Step 07: Temporally install the right Window.

04/18/15
 
Step 08: The Finished window.

09/13/18
Page 07.02 Plexiglas Windows
07.01 Aluminum 07.02 Plexiglass Windows  
01: Flush Rivets 02: Stab Fairings 03: Static Air / Pitot 04: Canopy Lock / Lift  05: Battery Location 06: Fuel Tanks
07: Rear Windows 08: Engine 09: Seat Adjustment 10: Seat Brace 11: Brake System 12: Electric Flaps
13: Rudder Trim 14: Tailcone Fairing 15: Wing Skin Stiffeners 16: Wing Tip Lights 17: Rear Baggage 18: Tailcone Camera
19: Tailcone Stiffeners 20: Tie Down Rings 22: Vent Door Knobs      
           
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.