Vans RV Builders List
Vans Parts Vendors
EAA FAA
Sun n Fun FAA Registry
Oshkosh NTSB
Home Empennage kit Wing Kit Fuselage Kit Finish Kit Power Plant Kit Avionics Paint Interior Home
Home Alterations Vendors Builders log  Home
Alteration 21 Seat brace handle
21.01                    
Page 01 NOTE: Any alteration will require it to be registered as Experimental-Amateur Built  E-AB
Parts
1 2"X 5" Aluminum Rod
1 8" X 3/4" Aluminum Tube
1 6" X 1" Black Heat Shrink

Start 11/05/18
Finished 11/11/18

This Alteration is to add a handle to the seat cross brace to help to enter and exit the Aircraft.

Step: 01 Make the reciver.


11/05/18
Step: 02: T
Step: 03:  Drill then Bore to the 3/4" the size of the tube use for the handle

11/11/18
Step: 04: A little work on the mill ( no photo ) then install the receiver in the cross brace.

11/11/18
Step: 05: Test fit the Handle


11/11/18
   
Page 21.01
21.01                    
01: Flush Rivets 02: Stab Fairings 03: Static Air / Pitot 04: Canopy Lock / Lift  05: Battery Location 06: Fuel Tanks
07: Rear Windows 08: Engine 09: Seat Adjustment 10: Seat Brace 11: Brake System 12: Electric Flaps
13: Rudder Trim 14: Tailcone Fairing 15: Wing Skin Stiffeners 16: Wing Tip Lights 17: Rear Baggage 18: Tailcone Camera
19: Tailcone Stiffeners 20: Tie Down Rings 22: Vent Door Knobs      
           
Drill Chart Tap Chart Bolt Chart Nut Chart Rivet Chart Washer Chart Rod Ends Vendors Shop Home
 

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.