| Home | Empennage kit | Wing Kit | Fuselage Kit | Finish Kit | Power Plant Kit | Avionics | Paint | Interior | Home |
|
|
|||||||||||
|
|||||||||||
| Home | Alterations | Vendors | Builders Log | Home |
| Alteration 06: Wing Tanks |
|
||||||||
| Page 06.02 Fuel Pumps | NOTE: Any alteration will require it to be registered as Experimental-Amateur Built E-AB | ||||||||
|
Parts
|
This alteration will install fuel tanks in the wings and modify the fuel system for this alteration
|
||||||||
| Step 01: Make
two fuel pump support brackets as shown. The slots in the flanges are to allow the brackets to move left or right 1/4" either way of center. This will help not to stress the fuel lines. 06/26/16 |
 |
||||||||
| Step 02: Use tank
sealant to bond rubber to the bottom of the fuel pump support
brackets as shown. 06/26/16 |
 |
||||||||
| Step 03: Install the
right and left fuel pumps to the fuel support brackets. 06/26/16 |
 |
||||||||
| Step 04: Make the front
and rear panels to make a compartment to house the fuel pumps. 06/26/16 |
 |
||||||||
| Step 05: Install fuel
pumps and panels. 06/26/16 |
 |
||||||||
| Step 06: Lay out and
cut as shown for the header tank fuel pump 05/14/16 |
 |
||||||||
| Step 07: Make the
header tank fuel
pump support bracket . 05/14/16 |
 |
||||||||
| Step 08: Install the support bracket as shown. |
 |
||||||||
| Step 09: Install fuel
pump and nutplates as shown. 06/04/16 |
 |
||||||||
| Page 06.02 Fuel Pumps |
|
|
|
||||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |